Predicting hourly litter moisture content of larch stands in Daxinganling Region, China using three vapour-exchange methods
Ping Sun A , Hongzhou Yu A and Sen Jin A BA College of Forestry, Northeast Forestry University, Hexing St. 26, Harbin, Heilongjiang Province 150040, PR China.
B Corresponding author. Email: jinsen2005@126.com
International Journal of Wildland Fire 24(1) 114-119 https://doi.org/10.1071/WF14098
Submitted: 31 March 2013 Accepted: 16 September 2014 Published: 5 January 2015
Abstract
Fuel moisture affects fuel ignition potential and fire behaviour. To accurately model fire behaviour, predict fuel ignition potential and plan fuel reduction, fuel moisture content must be assessed regularly and often. To establish models for Daxinganling Region, which has the most severe forest fires in China, hourly measurements were taken of moisture content in litter beds of larch stands sampled under different shading and slope conditions. Models were established using three vapour-exchange methods. The Nelson and Simard methods employed a direct timelag method using a timelag concept and the Nelson and Simard equilibrium moisture content (EMC) functions and estimating model parameters directly from fuel moisture and weather observation data in the field. The direct regression method used equations directly derived from linear regression of fuel moisture and field weather variation. The mean absolute error and mean relative error were determined for the Nelson (0.78%, 4.98%), Simard (1.04%, 5.57%) and direct regression (1.48%, 9.01%) methods. Only the models established using the direct timelag methods met the 1% accuracy requirement using either the Nelson or Simard EMC function, confirming the suitability and robustness of the direct timelag methods. The Simard and Nelson methods had similar accuracy, but Simard was more robust and only needed estimation of one parameter and hence is recommended for predicting litter moisture in this region.
Additional keywords: direct regression method, equilibrium moisture content, timelag.
References
Catchpole EA, Catchpole WR, Viney NR, McCaw WL, Marsden-Smedley JB (2001) Estimating fuel response time and predicting fuel moisture content from field data. International Journal of Wildland Fire 10, 215–222.| Estimating fuel response time and predicting fuel moisture content from field data.Crossref | GoogleScholarGoogle Scholar |
Chen HH, Ding ET, Cai XR, Hong W, Zhang ZY (1989) ‘Statistics Applied in Forestry.’ (Dalian Sea-transportation Press: Dalian)
Jin S, Chen PY (2012) Modelling drying processes of fuelbeds of Scots pine needles with initial moisture content above the fibre saturation point by two-phase models. International Journal of Wildland Fire 21, 418–427.
| Modelling drying processes of fuelbeds of Scots pine needles with initial moisture content above the fibre saturation point by two-phase models.Crossref | GoogleScholarGoogle Scholar |
Jin S, Li L (2010) Validation of the method for direct estimation of timelag and equilibrium moisture content of forest fuel. Scientia silvae sinicae 46, 95–102.
Liu X (2007) Effects of temperature and humidity on fuel equilibrium moisture content. MSc thesis, Northeast Forestry University, Harbin, China.
Matthews S, Gould J, McCaw L (2010) Simple models for predicting dead fuel moisture in eucalyptus forests. International Journal of Wildland Fire 19, 459–467.
| Simple models for predicting dead fuel moisture in eucalyptus forests.Crossref | GoogleScholarGoogle Scholar |
Nelson RM (1984) A method for describing equilibrium moisture content of forest fuels. Canadian Journal of Forest Research 14, 597–600.
| A method for describing equilibrium moisture content of forest fuels.Crossref | GoogleScholarGoogle Scholar |
Nelson RM, Hiers JK (2008) The influence of fuelbed properties on moisture drying rates and timelags of longleaf pine litter. Canadian Journal of Forest Research 38, 2394–2404.
| The influence of fuelbed properties on moisture drying rates and timelags of longleaf pine litter.Crossref | GoogleScholarGoogle Scholar |
Simard AJ (1968) The moisture content of forest fuels-1. A review of the basic concepts. Canadian Department of Forest and Rural Development, Forest Fire Research Institute, Information Report FF-X-14. (Ottawa, ON)
Slijepcevic A, Anderson WR, Matthews S (2013) Testing existing models for predicting hourly variation in fine fuel moisture in eucalypt forests. Forest Ecology and Management 306, 202–215.
| Testing existing models for predicting hourly variation in fine fuel moisture in eucalypt forests.Crossref | GoogleScholarGoogle Scholar |
Trevitt ACF (1991) Weather parameters and fuel moisture content: standards for fire model inputs. In ‘Proceedings of the Conference on Bushfire Modelling and Fire Danger Rating Systems’, 11–12 July 1988, Canberra, ACT. (Eds NP Cheney, AM Gill) (CSIRO Division of Forestry: Canberra, ACT)
Van Wagner CE (1987) Development and structure of the Canadian Forest Fire Weather Index System. Canadian Forestry Service, Forestry Technical Report 35. (Ottawa, ON)
Viney NR (1991) A review of fine fuel moisture modelling. International Journal of Wildland Fire 1, 215–234.
| A review of fine fuel moisture modelling.Crossref | GoogleScholarGoogle Scholar |
Wotton BM, Beverly JL (2007) Stand-specific litter moisture content calibrations for the Canadian Fine Fuel Moisture Code. International Journal of Wildland Fire 16, 463–472.
| Stand-specific litter moisture content calibrations for the Canadian Fine Fuel Moisture Code.Crossref | GoogleScholarGoogle Scholar |
Zhang YP (2008) ‘Study on the impacts of climate change on forest fires in Daxing’anling Mountains.’ MSc thesis, Northeast Forestry University, Harbin, China.
Zhou YL (1991) ‘Vegetation in Daxing’anling Mountains.’ (Science Press: Beijing)
