CSIRO Publishing Books Journals About Us Shopping Cart You are here: Journals > Australasian Plant Pathology   
Australasian Plant Pathology
  Research in all branches of plant pathology
 
Search
 
 
  Advanced Search
   

Journal Home
About the Journal
Content
Current Issue
Just Accepted
All Issues
Special Issues

 Australasian Plant Disease Notes
Disease notes, new records and quarantine interception reports are published in Australasian Plant Disease Notes.

 

Article << Previous     |     Next >>   Contents Vol 33(4)

Predicting the distribution of Endophyllum osteospermi (Uredinales, Pucciniaceae) in Australia based on its climatic requirements and distribution in South Africa

A. R. Wood A B D, P. W. Crous B C, C. L. Lennox A

A ARC — Plant Protection Research Institute, P. Bag X5017, Stellenbosch, 7599, South Africa.
B Department of Plant Pathology, University of Stellenbosch, P. Bag X1, Stellenbosch, 7602, South Africa.
C Centraalbureau voor Schimmelcultures, PO Box 85167, 3508 AD Utrecht, The Netherlands.
D Corresponding author. Email: Wooda@arc.agric.za
 
 Full Text
 PDF (1.3 MB)
 Export Citation
 Print
  


Abstract

The perennial bush Chrysanthemoides monilifera ssp. monilifera (Asteraceae) is infected by the autoecious, microcyclic rust fungus Endophyllum osteospermi. Both organisms are native to South Africa, whilst the plant has also become naturalised in Australia where it is the target of a biological control program. E. osteospermi is under consideration as a biocontrol agent for this weed. Temperature and light requirements for aecidioid teliospore germination and basidiospore development were studied, as was the nuclear cycle during germination. Aecidioid teliospores germinated between 10 and 20°C, with 15°C as optimum temperature. Light, and particularly near-UV light, stimulated germination whereas germination was poor under dark conditions. A period of 6–8 h of light was the minimum needed to obtain germination levels equivalent to continuous light. The temperature requirements for basidiospore development differed from that for aecidioid teliospore germination. Optimal basidiospore production was at 15°C, but a rapid decrease occurred at higher temperatures, with few developing at 19°C, despite a high germination rate at this temperature. Two nuclear divisions occurred within 12 h of germination initiation to produce a metabasidium with three or four nuclei. A third nuclear division occurred in the basidiospores that then germinated between 24 and 48 h. Plants inoculated under controlled conditions took 5 to 24 months after inoculation for witches’ broom symptoms to begin to develop. The detailed life cycle of E. osteospermi is presented. A Geographic Information System (GIS) approach was used to develop a model of the potential distribution of E. osteospermi in South Africa. This was based on monthly average climate surfaces with parameters derived from the above experiments. The parameters were modified so that the majority of all recorded localities of E. osteospermi in South Africa were included, whilst at the same time including only the minimum geographic area. The same model was applied to Australia to suggest a potential distribution of the rust fungus if released in Australia for the biological control of C. monilifera ssp. monilifera. This potential distribution was similar to one generated using the climate matching computer program CLIMEX, but gave greater spatial accuracy, at least in South Africa. Both approaches indicate that E. osteospermi should establish in temperate south-eastern Australia where C. monilifera ssp. monilifera is an invasive weed.

Keywords: nuclear cycle, life cycle, Boneseed, biological weed control.


   
    


 
Top  Email this page
 
Legal & Privacy | Contact Us | Help

CSIRO

© CSIRO 1996-2012